Loading...
P
P
Pr
r
re
e
ef
f
fa
a
ac
c
ce
e
e
45
LED Error Messages
POWER LED READY LED TEMP LED
ERROR CODE MESSAGES
Green Red Red Red
Lamp Ready ON ON
Start ON
Cooling ON flashing
Over Temperature OFF ON
Thermal Break Sensor error 7 blinks
Lamp Error 5 blinks
Burner Fan error 6 blinks 1 blinks
System Fan error 6 blinks 2 blinks
Power and Ballast Fan error 6 blinks 3 blinks
Case Open 7 blinks
DMD error 8 blinks
Color wheel error 9 blinks
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before re-
starting the projector. If the Power or READY LEDs are still blinking or the Over Temp LED is lit,
contact your service center.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control or projector.
3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed
Check the Projection setting on the SYSTEM SETUP : Basic > Projection menu of the
OSD.
Problem: The image is streaked
1. Set the Frequency and Tracking settings on the Computer menu of the OSD to the de-
fault settings.
2. To ensure the problem is not caused by a connected PC’s video card, connect to another
computer.
Problem: The image is flat with no contrast
Adjust the Contrast setting on the Image menu of the OSD.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com