Using the 1:11 HDD Copy Cruiser
The “Copy HDD” function performs an actual copy from a source HDD to one or
more target HDDs. The target HDDs must be at least as large as the source. The 1:11
HDD Copy Cruiser will copy every block of capacity on the source HDD.
1. Load the source HDD and the target HDDs into the 1:11 HDD Copy Cruiser.
The system will auto-detect the hard drives. After the drives have been
detected, a screen similar to the one below will be displayed.
Note: Before copying be sure that the capacity of the target HDD is equal to or
larger than the source hard drive.
2. Press ENT to start copying. The system will auto-detect the hard drives. The
following information will be displayed.
3. During the copy process the 1:11 HDD Copy Cruiser will display progress
The amount of data remaining to be transferred (shown in gigabytes), and time
will be displayed as the percentage of completion increases.
Note: The copying speed, capacity and duration may vary from one source hard
drive to another.
1. Copy HDD
Copy- 36MB/s 0%