DU8190Z DLP Projector - User Manual
Off: Turn off High Altitude mode if the projector is installed in an area under 5000 feet.
On: Turn on High Altitude mode if the projector is installed in an area over 5000 feet.
Auto: Set up this mode automatically by estimated altitude.
Auto Power Off
This function is set to OFF by default. When it is set to ON and no input signal is received within 20 minutes, the projector
will turn off automatically.
Auto Power On
This function is set to OFF by default. When it is set to ON, the projector will turn on automatically when y AC power is
turned on next time. You can use this function and the power switch (instead of the remote control) to turn on the projector.
Set this function to OFF if it’s unnecessary.
Use this function to configurator the network settings so that you can control the projector via the network.
Press ▲▼ and Enter button to select Network and network settings. Please refer to Remote Communication Manual for
This option allows you to set up power consumption at standby status,
On: Projector maintains in the standby at higher power consumption (< 6W) for projector control via LAN. In this
mode, the projector can be turned on by RS-232 command or web control.
Off: Projector maintains in the standby at lowest power consumption (<0.5W), the projector can be turned on by
the power button on the remote control or control panel only.
DHCP: Set DHCP to ON/OFF. When DHCP is set to ON, the DHCP server of the domain will assign an IP address to
the projector. The IP address will appear on the IP address window without need to make any input. If the domain
cannot assign any IP address, 0.0.0.0 will be shown on the IP address window.
IP Address: To specify an IP address, press the Enter button to show the IP address input window. Use the ◄►
button to select the number in the address to change. Use the ▲▼ button to increase or decrease the number in the IP
address. Network IP Address 172. xxx. xxx. xxx.
Subnet Mask: Set the subnet mask. The input method is the same as the setting for IP address.
Gateway: Set the gateway. The input method is the same as the setting for IP address.
DNS: Set the DNS. The input method is the same as the setting for IP address.
MAC Address: Show projector’s MAC Address.
Use the ◄► function to select the Eco, Normal or Custom Power Level mode.
Eco: Projection operates in the energy-saving mode, which is equivalent to 80 % power of light source.
Normal: Projection operating with normal light power can obtain the brightest projection display.
Custom Power Level: User can decide the power level depending on his or her preference.
Custom Power Level
Use the ◄► function to select the Custom Power Level. This function is available only when the Light Power is set to
Custom Power Level, which range is allowed to adjust from 20% to 100% of normal mode, and it cannot be selected
under the Normal or Eco mode.
Estimate Altitude is calculated by atmosphere pressure, it may have the tolerance comparing to actual altitude.
If any over temperature or system protection message, please adjust High Altitude by Manual.
In some application, regular cooling fan setting may not supply enough cold air for system cooling even the
projector is installed in an area under 5000 feet. In this case, please set High Altitude to On.