Loading...
D
D
DL
L
LP
P
P
P
P
Pr
r
ro
o
oj
j
je
e
ec
c
ct
t
to
o
or
r
r
U
U
Us
s
se
e
er
r
r
s
s
s
M
M
Ma
a
an
n
nu
u
ua
a
al
l
l
5
ITEM
LABEL
DESCRIPTION
SEE PAGE:
15.
VGA OUT
Connect the RGB cable to a display.
(Pass through by VGA1 only)
16.
AUDIO OUT
Connect an AUDIO cable for audio loop through.
17.
BNC
Connect a BNC cable from a computer.
18.
IR receiver
Receive IR signal from remote control.
7
19.
SERVICE
For service use.
20.
RS-232
Connects RS-232 serial port cable for remote control.
21.
12V
When connected to the screen through a commercially available cable,
the screen deploys automatically on start up of the projector. The screen
retracts when the projector is powered off (see notes below).
22.
WIRED REMOTE
Wire remote control connector (connect with wire remote connector of the
Remote Control set).
23.
AUDIO IN 3 L/R
RCA (YPbPr)
Connect the audio cables from a audio device.
24.
AUDIO IN 4 L/R
RCA (Video/ S-
Video)
Connect the audio cables from a audio device.
25.
VIDEO
Connect the composite cable from a video device.
26.
S-VIDEO
Connect the S-video cable from a video device.
27.
YPbPr
Connect a component video enabled device.
28.
AC IN
Connects the power cable.
13
29.
Power switch
Turns on/off the projector.
30.
Security chain
lock
Helps protect the projector from unauthorized use.
61
31.
Kensington Lock
Secures to permanent object with a Kensington® Lock
system.
Note:
To use this feature, you must plug in the connector before turn on/off the projector.
Screen controllers are supplied and supported by screen manufacturers.
Do not use this jack for anything other than intended use.
Note:
If your video equipment has both S-VIDEO and RCA jacks (composite video) connect to the
S-VIDEO connector. S-VIDEO provides a better quality signal.
Warning:
As a safety precaution, disconnect all power to the projector and connecting devices before
making connections.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com