Loading...
RC-43SL - Overview
5
3.1 Defining the RC-43SL 6-Button Room Controller
This section defines the RC-43SL.
Figure 1: RC-43SL 6-Button Room Controller
#
Feature
Function
1
Six Touch-sensitive Buttons
Program button functions on the connected room
controller
2
Six LEDs
Flash yellow when the button is touched. Each LED
can be custom programmed to light on specific
actions
3
DIP-switches
Access by removing K-Net connector. Left switch
reserved, right switch 120Ω K-Net terminator (see
Section 4.1)
4
Ground Terminal Connector
Connects to ground to earth the device
5
USB Connector
Connects to a computer for unit configuration and
firmware upgrading
ETHERNET RJ-45 Connector
Connects to the PC or other LAN device through a
networking LAN
7
IR OUT Terminal Blocks
Connect to IR emitter cables (from 1 to 2)
8
FACTORY DEFAULT Button
Using a small screwdriver, press to perform a
factory reset
IR IN Sensor
Used for IR learning
10
K-NET Terminal Block
PIN +12V is for powering this (and another) unit,
PIN A (+) PIN and PIN B (-) are for RS-485, PIN
GND is for the ground connection
The ground connection is sometimes connected to the shield
of the RS-485 cable
To supply 12V to another device, connect its 12V power line
to the +12V DC terminal of this device
11
RS-232 Terminal Blocks
Connect to the RS-232 devices (from 1 to 2)
12
RELAYS Terminal Blocks
Connect to low-voltage relay-driven devices
(from 1 to 3)
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com