Shell Command Buttons
3. In the Name box, enter the name of the
input source, i.e. DakStats. Refer to
Figure 6.
4. Select the Source Type or communication
device desired from the drop-down menu.
5. Select the Source.
6. If necessary, select the Baud Rate.
Note: Data sources send information at
different baud rates, parity and data bits.
Consult the data source manual to find the
appropriate settings.
7. If necessary, select the Parity from its
drop-down menu. The parity determines
if data is sending properly.
8. If necessary, select the Data Bits, or the speed at which information should transfer,
from the drop-down menu.
9. Select the Default Input Template. This is required for All Sport, ProSport, etc.
10. Once all appropriate boxes are filled, click OK to return to the RTD Input menu.
11. Click OK to return to the System Configuration menu. Click OK to return to the
Shell menu.
Note: The Sign Service will need restarting in order for the configuration to take
effect. A message prompts for service restart; click Yes to restart the sign service.
Another message asking whether to stop any running signs appears; click Yes.
Finally, a message asking whether to stop the Remote Service appears; click Yes.
This process causes the live display to momentarily go blank while the Venus 7000
sign service restarts.
Driver Conversions
The Driver Conversions tab converts Venus 6000
drive letters to Venus 7000 file servers. Refer to
Figure 7.
Edit Drive: allows users to make changes
to the selected drive conversion.
Add Drive: allows users to add a new
drive conversion.
Delete Drive: allows users to remove a
drive conversion.
Figure 6: Edit RTD Input
Figure 7: Driver Conversions
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com