Loading...
54
en-us Installation and connection
Electrical connection
Connect the appliance to an 120 V, 60 Hz alternating
current only, via a correctly installed outlet with
protective grounding conductor. See rating plate for
required fusing 9:.
The outlet must be near the appliance and freely
accessible after the installation.
If the plug is not freely accessible, an allpole
disconnector with a contact opening of at least 3 mm
must be fitted on the installation side to satisfy the
relevant safety instructions.
The connection may be modified by technicians only.
A power cord extension may be purchased from
customer service only.
Use only a residual current operated circuit-breaker
which features the symbol . Only this extension
guarantees compliance with the currently valid
regulations.
The appliance features a water damage protection
system. Please note the system will function only
when the power supply is connected.
Removing the appliance
Also observe the sequence of worksteps here.
1. Disconnect the appliance from the power supply.
2. Turn off the tap.
3. Undo the drain water and water supply connection.
4. Loosen fastening screws for the cabinet parts.
5. If fitted, remove the base panel.
6. Pull out the appliance, carefully pulling the hose
behind.
Transporting the appliance
Empty the dishwasher and secure loose parts.
Drain the appliance according to the following steps:
1. Turn on the tap.
2. Open the door.
3. Switch on ON/OFF button (.
4. Select wash cycle with the highest temperature.
The estimated wash cycle duration is indicated on
the digital display @.
5. Press START button )".
6. Close the door.
Wash cycle sequence starts.
7. Open the door after approx. 4 minutes.
8. Press START button )" until “Program was
terminated”/“Ready in one minute.” is indicated at
the digital display @.
9. Close the door.
10. Open the door after approx. 1 minute.
The digital display @ indicates; “Finished”.
11. Switch off ON/OFF switch (.
12. Turn off the tap, disconnect supply hose and drain
water.
Note: Transport appliance upright only. This prevents
residual water from running into the machine control
and damaging the wash cycle sequence.
Securing the appliance against frost
If the appliance is in a room where there is a risk of frost
(e.g. holiday home), empty the appliance completely
(see “Transporting the appliance”).
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com