Loading...
44
en-us Troubleshooting
Food soils on the dishes. Dishes placed too closely together,
racks overfilled.
Arrange dishes with adequate clearance
between them ensuring that the spray jets
can reach the surface of the dishes. Prevent
contact points.
Spray arm rotation obstructed. Arrange dishes so that the spray arm can
rotate without obstruction.
Spray arm nozzles are blocked. Clean the spray arm nozzles.
Filters 1Z dirty. Clean filters.
Filters 1Z inserted incorrectly and/
or not engaged.
Insert and engage filters correctly.
Rinse wash cycle too weak. Select a more intensive rinse cycle.
Increase sensitivity of the sensors.
Dishes precleaned too intensely;
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
Do not prerinse dishes. Remove only large
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle "Regular" or
Intensive.
Tall narrow containers in corner areas
are not rinsed adequately.
Do not place hollow containers too
obliquely and do not place in the corner
area.
Upper rack 12 on right and left not
set to same height.
Set upper rack to same height using side
levers.
Dishwasher seems to run a long
time
Incoming water is not warm enough. Before starting a cycle, run hot water faucet
at the sink closest to the dishwasher.
Cycle time can vary due to soil and
water conditions.
Sensors in the dishwasher automatically
increase the cycle time to ensure a good
wash when heavy soil is detected.
Rinse aid dispenser 9" is empty. Add rinse aid.
Dishwasher connected to cold water
supply.
Note:Check the typical wash cycle
length.
Verify dishwasher is connected to hot water
supply plumbing.
Detergent residue. Detergent dispenser cover 9*
blocked by dishes and therefore does
not open fully.
Dishes must not be placed above the
detergent tab tray 1B. These may block the
lid of the detergent dispenser and prevent it
from opening fully.
Do not place dishes or fragrance dispenser
in the detergent tab tray.
Detergent dispenser cover 9*
blocked by the detergent tab.
Detergent tab must be inserted flat and not
upright.
Detergent tab used in the quick or
short wash cycle.
Dissolving time of the detergent is
not reached in the selected short
wash cycle.
Dissolving time of detergent tab too long for
a quick or short wash cycle.
Use a detergent powder or select a more
intensive wash cycle.
Washing effect and dissolving
performance are reduced after a
prolonged storage time or detergent
is very lumpy.
Change detergent.
Fault Cause Remedial action
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com