Loading...
17
Switching off automatically after
the end of the programme
To save energy, the dishwasher is switched off
1 minute after the programme ends (factory setting).
Automatic disconnection can be adjusted from ˜:‹‹
to ˜:‹ƒ.
1Open the door.
2Switch on ON/OFF switch (.
3Hold down programme button # and press
START button )" until :... is indicated on the
digital display.
4Release both buttons.
The LED for button # flashes and the digital
display 8 displays the factory setting :‹….
5Press programme button # until the factory set
value ˜:‹‚ is indicated on the digital
display 8.
To change the setting:
1Press programme button 3.
Each time the button is pressed, the set value
increases by one level; when the value of ˜:‹ƒ
has been reached, the display jumps back
to ˜:‹‹ (off).
2Press START button )".
The set value is saved.
3Close the door.
Switching off the appliance
Short time after the end of the programme:
1Open the door.
2Switch off ON/OFF switch (.
3Turn off the tap (not applicable if Aqua-Stop
fitted).
4Remove the utensils when they have cooled down.
ã=Warning
At the end of the programme please open the door
fully and not partially when emptying the dishwasher.
Any escaping water vapour could damage sensitive
worktops.
Interrupting the programme
1Open the door.
2Switch off ON/OFF switch (.
The LEDs go out. The programme is saved.
If the door was opened on an appliance which has
a warm water connection or is heated, first leave
the door ajar for several minutes and then close.
Otherwise, expansion (pressure) may cause the
appliance door to spring open or water to run out
of the appliance.
3To continue the programme, switch on the ON/
OFF switch ( again.
4Close the door.
Terminating the programme (Reset)
1Open the door.
2Press START button )" for approx. 3 sec.
The numerical display 8 indicates :‹‚.
3Close the door.
The programme sequence lasts approx. 1 min. On
the digital display 8 is indicated :‹‹.
4Open the door.
5Switch off ON/OFF switch (.
6Close the door.
Changing the programme
When the START button )" has been pressed, the
programme cannot be changed.
The only way a programme can be changed is by
Cancel programme (Reset).
˜:‹‹ Appliance does not switch off automatically
˜:‹‚ Off after 1 min
˜:‹ƒ Off after 120 min
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com