Loading...
11
Timer functions
You can set the following timer functions:
Cooking time
Cooking time end
Timer
Stopwatch
Alarm clock function
Use the operator control keys to operate the timer
functions. Visual and audible signals assist you with
operation:
Note: when you press the M key, set times are
displayed for 10 seconds.
Correcting an input:
Press the M key. Within 10 seconds, correct the time
value with the @ and A keys. Confirm input with the ~
key. To clear an input, press the @ and A keys at the
same time.
Cooking time
If you set a cooking time for your meal, the appliance
switches off heating automatically after this time has
elapsed.
You can set a cooking time from 1 minute to 23 hours
59 minutes.
Place your meal in the oven and set the temperature
and mode you require with the temperature and mode
selectors.
Programming the cooking time:
1Press the M key once. The × and Ò symbols
flash. The time display shows ¬¬:¬¬ or the
current duration.
2Set the required duration with the aid of the @
and A keys.
3Press the start key ~. The × symbol goes off and
the Ò lights up continuously.
After expiry of the duration:
The Ò flashes. An audible signal is sounded. The
appliance ends heating. Press any key. Ò goes off,
the signal tone goes off and heating is started again.
Now set the temperature control to 0° C.
Correcting an input:
Press the M key. Within 10 seconds, correct the time
value with the @ and A keys. Confirm input with the ~
key. To clear an input, press the @ and A keys at the
same time.
End of cooking time
With this function you can move the end of the set
cooking time to a later point in time.
To do this, enter the cooking time and program the
required time for the end of the cooking time. The
electronic circuitry calculated the corresponding
starting time and starts cooking automatically.
Note: note that easily perishable foodstuffs must not
be left in the oven for too long.
Proceed as follows:
1Set a cooking time (see section entitled "Cooking
time")
2Press the M key twice. The × and Ò symbols
flash. The time display shows ¬¬:¬¬ or the
current duration.
Short deep
tone
Selection is being made
Short high
tone
Input completed
Deep tone
sequence
Programmed value reached, awaiting
confirmation
Flashing
display symbol
Awaiting input or confirmation
Dashes in the
display
No value programmed
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com