Loading...
4209-51 06-08-09
page 5
SECTION 2: K200i REMOTE OPERATION
To start the remote display, push any button on the remote. The start up logo appears in 2 seconds followed by the
main menu. (pushing any button once the start up logo is displayed, will take you immediately to the main menu
without delay). The remote display stays lit for 30 seconds after the last button push, then goes into a battery
conservation sleep mode. To restart or wake up the display, push any button on the remote.The remote control is
programmed by selecting function icons using the up, down, left and right arrows on the key pad and then locking in
the setting desired by pushing the “select / enter” center button. The “select / enter” center button can be pressed at
any time to lock in any previous adjustments and return to the prior menu.
BATTERY CHARGE LEVEL
TIME OF DAY (OR BATH REMAINING
DURATION IF BATH ON)
DISPLAY USER PROFILE
SETTING
OPTIONS; LIGHTS, AROMA, FAN
TOOLS; USER PREFERENCES, 60 MIN
OR 24 HR DURATION MAX, WARM
START, SET TIME AND DAY, RE-SYNC
CONTROL TO HUB
BACK ONE MENU BUTTON
NAVIGATION ARROWS BETWEEN
ICONS
STEAM ROOM TEMPERATURE
ROOM TEMPERATURE SETTING
STEAM BATH DURATION
START STEAM BATH ON / OFF
HOME / MAIN MENU BUTTON
SELECT / ENTER BUTTON
START THE STEAM BATH CYCLE
With the “start steam bath on / off” icon highlighted press the “SELECT / ENTER” button to start the bath
cycle with the last settings used or set. (If a Red x appears next to the on/off icon, it indicates the remote
control or dock are not receiving a signal from the RF Hub. If this occurs, move the remote control closer
to the RF Hub or change the location of the RF Hub. It takes approximately 10 seconds to re-establish
connection once it is lost and then available again).
SET TEMPERATURE
From the main menu use the up arrow to highlight the thermometer, then press the “SELECT / ENTER”
button.
RED "X" BY ANY ICON
(NO COMMUNICATION TO RF
HUB. SEE SECTION 4)
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com