Loading...
4209-51 06-08-09
page 12
SECTION 4: RF HUB
RF HUB OPERATION
The RF HUB is connected to Jack J9 (marked wireless hub) on the printed circuit board inside the steam generator
with a 25 foot cable. The hub relays signals to and from the remote control, remote control dock and the generator.
RF HUB MOUNTING
The RF HUB 25 foot cable allows mounting in multiple locations. Typically the mounting location should be high on a wall
near or above the steam shower. The location should be indoors and dry. The mounting location should be tested to insure
that signals from the remote control dock and locations where the remote control is planned to be used, receive a steady signal
(no Red x appears on the display by any icon) and Steam room temperature is consistently displayed when the bath is on.
RF Hub mounting locations with metal or metal studs between the remote, dock and hub should be avoided. See diagrams
below for suggested RF Hub mounting.
SECTION 5: REMOTE CONTROL CHARGING
The K200i comes with a 120 Volt charger for recharging the remote control batteries. Simply place the remote into the
charger, which is plugged into a 120 Volt outlet, and the batteries will be fully recharged in approximately 4 hours.
Best (within 10 feet
and Hub orientation
as shown)
Poor (within 25 feet
and Hub orientation
as shown)
Better (within 25 feet
and Hub orientation
as shown)
Avoid interrupting metal barriers,
such as a furnace or water heater,
between the RF Hub and the Remote
Control and Remote Control Dock.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com