Loading...
4209-51 06-08-09
page 11
SECTION 3: REMOTE CONTROL DOCK
DOCK OPERATION
The remote control dock mounts inside the steam room, acts as a dock for the remote control, includes a built in
temperature sensor, an on/off button for starting or stopping the steam bath (if the remote is not available) and a
blinking LED light which indicates if the steam bath is on or off during the “on” cycle.
DOCK MOUNTING
The remote control dock should be mounted inside the steam room 4 feet up from the floor not in the direct spray of
the shower head and not directly over the steam head (over the steam head mounting will give the temperature
sensor false readings). The dock mounts on the dock mounting plate which is attached to the steam room wall using
either the adhesive gasket supplied or alternatively with mounting screws (not provided) for a permanent mounting
(screws require pre-drilling holes into the steam-
LED LIGHT
ON / OFF BUTTON
TEMPERATURE SENSOR
OPTIONAL MOUNTING SCREWS
DOCK MOUNTING PLATE
ADHESIVE GASKET
REMOTE CONTROL DOCK
room wall material). Once the dock mounting plate is
attached to the steam room wall, the remote control
dock will slide down on to the dock mounting plate and
lock in place. To remove the remote control dock
simply slide the dock up and off of the mounting plate.
If the remote control dock is replaced or the batteries are replaced. The dock may require re-syncing (remote control
may not display steam room temperature). To re-sync the dock, press and hold the dock on/off button for several
seconds until it begins to blink rapidly. This procedure should be performed within 4 minutes of turning the breaker
power off and then back on to the steam generator.
RE-SYNC DOCK TO RF HUB
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com