Loading...
ÂRXD Indicator: Lights when commands or data are
received via the Control Module's RS232 Connector.
ÃRS232 Connector: An RJ-11 jack for connection to your
PC, control device, or external modem. Please refer to
Appendix A for a description of the RS232 interface.
ÄAUX Connector: (Not Shown) A four wire quick
connector, located on the back edge of the Control Module
board. Used for connection to an optional external alarm
device and monitored line. Please refer to Appendix A for
a description of the AUX Connector interface.
ÅRS232 Baud Rate Jumper: (Not Shown) Jumper J1,
located on the Control Module board, is used to select the
baud rate for the RS232 port (Section 3.3.1).
ÆMaster A/B Gang Switch Jumper: (Not Shown) Jumper
J2, located on the Control Module board, is used to
enable/disable the Master A/B Gang Switch
(Section 3.3.2).
ÇMonitor Input Level Jumper: (Not Shown) Jumper J3,
located on the Control Module board, is used to force AUX
Port Pin 4 to normally high or normally low
(Section 3.3.3).
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com