Loading...
4. Type ]P N and press [Enter] (where "N" is the Circuit
Module selected for Monitor Mode setup). When the
Circuit Parameters Screen appears (Figure 5.1), type 7and
press [Enter] to enable the Monitor Mode. The screen will
display the following seven additional prompts (items 8
through 14):
Note:
It is not necessary to repeat this step for each
Circuit Module that will be switched.
When the ]P command is invoked, make certain to
specify the Circuit Module that was selected in
Section 5.3, Step 1. For example, to use Circuit
Module 3 for Monitor Mode setup, type ]P 3
[Enter].
The Circuit Module used for Monitor Mode setup
must be properly installed, and the Monitor Jumper
on the Circuit Module's card must be present (see
Section 3.4).
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com