Loading...
3.7.1. Default Parameters Option
This method allows default parameters to be set without effecting the On/Off status of the TPS's two
switched plugs. To reset the unit to default parameters, proceed as follows:
1. Access the TPS Command Mode (see Section 5.1).
2. At the TPS> command prompt, type /G and press [Enter]. The General Parameters menu will
appear.
3. From the General Parameters menu, type Aand press [Enter]. If command confirmation is
enabled, the unit will display a "Sure?" prompt. Type Yand press [Enter] to proceed with the reset
procedure. After a brief pause, parameters will be reset to default values.
Note: If the Default Parameters function is invoked via the Network Port, the IP Address
will not be reset. If this function is invoked via the Console Port or Modem Port, the IP
Address will be reset.
3.7.2. Default Button (Local)
Typically, this method is used when devices have not been connected to the TPS unit, and you have
immediate access to the installation site.
Note: This method will temporarily switch all plugs Off.
Set the Master Power Switch to the OFF position. Press and hold the Default Button, located on the
instrument back panel. Place the Master Power switch in the ON position. Wait about 5 seconds, and
then release the Default Button.
7
TPS Series Telnet Power Switches; User's Guide Installation
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com