7. Saving and Restoring
Configuration Parameters
After the RPC-4850-8N has been properly configured, parameters can be
downloaded and saved as an ASCII text file on your local or remote PC. Later,
if the configuration is accidentally altered, the file with the saved parameters
can be uploaded to automatically reconfigure the unit without the need to
manually assign each parameter.
Saved parameters can also be uploaded to other RPC units. This allows rapid
set-up when several units will be configured with the same parameters.
The "Save Parameters" procedure can be performed from any terminal
emulation program (e.g. ProComm, Crosstalk, Hyperterminal, etc.), which
allows downloading of ASCII files.
Note: Although this function is only available via the Text Interface,
parameters that are defined via the Web Browser Interface will also be
sent to the ASCII file.
7.1. Sending Parameters to a File
1. Start your communications program and access the RPC command mode
using the System Password.
2. When the RPC command prompt appears, type /DL and press [Enter].
The RPC will prompt you to prepare your communications program. Set
up your communications program to receive an ASCII download, and
specify a name for the file that will receive the saved parameters
(e.g. RPC.PAR).
3. When the communications program is ready to receive the file, return to
the RPC command mode, and press [Enter] to proceed.
4. The RPC will send a series of ASCII command lines which specify the
currently selected RPC parameters.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com