Loading...
6-4
RPC-4850-8N Remote Power Controller - User’s Guide
6.2.2. Switching and Reboot Commands - Text Interface
These commands can Boot or toggle the RPC’s switched circuits. Circuits
may be specified by name or number.
Notes:
Wait for the "RPC>" prompt to appear before entering additional
commands. The prompt will not reappear until the previous
command is complete.
Commands are not case sensitive. All commands are invoked by
pressing [Enter].
Users who login to command mode using a Circuit password, will
only be allowed to issue commands to the circuits allowed by that
password.
If command confirmation is enabled, the RPC will display the Status
Screen after switching commands are successfully completed.
When switching and reboot operations are initiated, Boot/Sequence
Delay times will be applied as described in Section 5.3.3.2.
Remote Power Controller v1.41i Site ID: (undefined)
Display Configuration
/H Display Help Screen /G View/Set General Parameters
/S Display Circuit Status /P [n] View/Set Circuit Parameters
/SN Display Network Status /C View/Set Serial Parameters
/N View/Set Network Parameters
Control /T View/set Telnet Parameters
/D Set Circuits to Default /W View/Set Web Server
/Boot <n> Boot Circuit n /E Save Parameters
/On <n> Turn On Circuit n /R Recall Parameters
/Off <n> Turn Off Circuit n /DL Download Parameters to File
/X Exit/Disconnect
Utilities
+------------------------------------+ /I Reset Network Interface
| [n] = optional CKT name or number | /U Upgrade Firmware
| <n> = required CKT name or number |
| n+n or n n = CKT n and CKT n |
| n:n = CKT n through CKT n |
| * = all CKTs |
| ,y = bypass “Sure? (y/n)” |
+------------------------------------+
RPC>
Figure 6.3: The RPC Help Screen - Text Interface
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com