Loading...
5-2
Basic Configuration
To access command mode via the Text Interface, proceed as follows:
Note: When communicating with the unit for the first time, you will not be able
to contact the unit via Telnet until you have accessed command mode, via Local
PC or SSH Client, and used the Network Parameters Menu to enable Telnet as
described in Section 5.9.
1. Contact the RSM-8R4 Unit:
a) Via Local PC: Start your communications program and press [Enter]. Wait
for the connect message, then proceed to Step 2.
b) Via Network: The RSM-8R4 includes a default IP address (192.168.168.168)
and a default subnet mask (255.255.255.0.) This allows you to contact the
unit from any network node on the same subnet, without first assigning an IP
Address to the unit. For more information, please refer to Section 5.9.
i. Via SSH Client: Start your SSH client, and enter the RSM-8R4’s IP
Address. Invoke the connect command, wait for the connect message,
then proceed to Step 2.
ii. Via Telnet: Start your Telnet Client, and then Telnet to the RSM-8R4’s IP
Address. Wait for the connect message, then proceed to Step 2.
c) Via Modem: Use your communications program to dial the number for the
phone line that you have connected to the RSM-8R4's internal modem port.
2. Login / Password Prompt: A message will be displayed, which prompts you to
enter a username (login name) and password. The default username is "super" (all
lower case, no quotes), and the default password is also "super".
3. If a valid username and password are entered, the RSM-8R4 will display the Port
and Plug Status Screen, shown in Figure 5.1.
Remote Site Manager + Power Control Site ID: (undefined)
PORT | NAME | USERNAME | STATUS | MODE | BUFFER COUNT
-----+------------------+------------------+--------+--------+--------------
01 | (undefined) | | Free | Any | 0|
02 | (undefined) | | Free | Any | 0|
03 | (undefined) | | Free | Pass | 0|
04 | (undefined) | | Free | Pass | 0|
05 | (undefined) | | Free | Pass | 0|
06 | (undefined) | | Free | Pass | 0|
07 | (undefined) | | Free | Pass | 0|
08 | (undefined) | | Free | Pass | 0|
09 | MODEM | | Free | Modem | 0|
PLUG | NAME | STATUS | BOOT DELAY | DEFAULT | PRIORITY
-----+--------------------------+--------+------------+---------+----------
1 | Outlet1 | ON | 0.5 Secs | OFF | 1 |
2 | Outlet2 | ON | 0.5 Secs | OFF | 2 |
3 | Outlet3 | ON | 0.5 Secs | OFF | 3 |
4 | Outlet4 | ON | 0.5 Secs | OFF | 4 |
* = Plug in BUSY state System Temperature: 59F
Enter /H for command menu.
RSM>
Figure 5.1: The Port and Plug Status Screen
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com