When switching and reboot commands are executed, the RSM-8R4 will display a
"Sure?" prompt, wait for user response, and then complete the command. The unit will
pause for a moment while the command is executed, and then return to the Port and
Plug Status Screen.
To Switch Plugs, or initiate a Reboot Cycle, proceed as follows:
1. Switch Plug(s) On: To power-on a plug or Plug Group, type /ON n and press
[Enter]. Where "n" is the number or name of the desired plug or Plug Group. For
/ON 1 [Enter] or /ON ROUTER [Enter]
2. Switch Plug(s) Off: To power-off a plug or Plug Group, type /OFF n and press
[Enter]. Where "n" is the number or name of the desired plug or Plug Group. Note
that the “/OFF” command can also be entered as “/OF”. For example:
/OFF 2 [Enter] or /OF ROUTER [Enter]
3. Reboot Plug(s): To initiate a Boot cycle, type /BOOT n and press [Enter]. Where
"n" is the number or name of the desired plug or Plug Group. Note that the "/BOOT"
command can also be entered as "/BO". For example:
/BOOT 3 [Enter] or /BO ATMSWTCH [Enter]
4. Set All Plugs to Power Up Defaults: Type /DPL and press [Enter]. All plugs
permitted by your account will be set to their default On/Off status, which is defined
via the Plug Parameters Menu as described in Section 5.7.
• When you have accessed command mode using an account that permits
Administrator or SuperUser level command access, the Default command will
be applied to all plugs.
• When you have accessed command mode using an account that only
permits User level command access, the Default command will only be
applied to the plugs specifically allowed by that account.
• The /DPL command is not available in ViewOnly mode.
5. Suppress Command Confirmation Prompt: To execute a Boot/On/Off
command without displaying the "Sure?" prompt, you can either disable command
confirmation via the System Parameters Menu, or include the ",Y" option at the end
of the command line. For example:
/ON ROUTER,Y or /BOOT 2,Y