Loading...
Table of Contents
1. Introduction .............................................1-1
2. Unit Description ..........................................2-1
2.1. Front Panel ..........................................2-1
2.2. Back Panel ..........................................2-2
3. Getting Started ...........................................3-1
3.1. Communication Parameters .................................3-1
3.2. Connecting your PC to the CPM ..............................3-1
3.3. Apply Power to the CPM ..................................3-2
3.4. Communicating with the CPM Unit ............................3-3
4. Hardware Installation .......................................4-1
4.1. Configure Setup Switches ..................................4-1
4.1.1. Default Baud Rate (Sw1, Sw2, Sw3) .......................4-1
4.1.2. Default Handshake (Sw4) .............................4-2
4.1.3. Default Response Message Format (Sw5) ....................4-2
4.1.4. Default Command Echo (Sw7) ..........................4-2
4.2. Connecting a Modem to the CPM .............................4-3
4.3. Initialize the Unit to Default Settings ...........................4-3
4.4. Connecting Devices to the CPM ..............................4-4
5. Configuration ............................................5-1
5.1. Access to the CPM Command Mode ............................5-1
5.2. Defining and Reading the Site I.D..............................5-2
5.3. Port Configuration ......................................5-2
5.3.1. Configuration Conventions ............................5-2
5.3.2. Port Modes......................................5-3
5.3.2.1. The Any-To-Any Mode .........................5-3
5.3.2.2. The Modem Mode ............................5-3
5.3.3. Command Availability ...............................5-4
5.3.4. Port Configuration Commands ..........................5-4
6. Operation ..............................................6-1
6.1. Port Connection and Disconnection ............................6-1
6.1.1. Using ASCII Commands to Connect Ports ...................6-1
6.1.2. Disconnecting Ports ................................6-2
6.2. Defining Hunt Groups ....................................6-3
6.3. Port Buffers ..........................................6-4
7. Saving Configuration Parameters ................................7-1
7.1. Sending Parameters to a File ................................7-1
7.2. Restoring Saved Parameters.................................7-2
8. Command Reference Guide ...................................8-1
8.1. Command Conventions ...................................8-1
8.2. Command Response .....................................8-2
8.3. Command Summary .....................................8-3
8.4. Command Set .........................................8-4
i
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com