Loading...
19-1
19 . Command Reference Guide
19.1. Command Mode Access
When the VIP has been properly installed and configured, command mode
can be accessed by a local PC connected directly to the Console Port, by a
remote PC that communicates via modem, or via TCP/IP network.
Notes:
If the Site I.D. Message (System Parameters Menu, Item 4) has
been defined, the Site I.D. will be displayed before the "PollCat-
NetLink" prompt.
When the Supervisor Password is entered, the VIP will start up in
Supervisor Mode, allowing access to all menu functions. When
a User password is entered, the VIP will start up in User Mode,
which allows limited access to menu functions.
The Default Supervisor Mode Password is SUPER, and the
default User Mode Password is SMDR.
1. Remote Access (via Modem): Start your communications program
and dial the VIP.
a) The unit will respond with the "PollCat-NetLink" (password)
prompt after the carrier is detected.
b) Key in a valid password and press [Enter]. Note that the
Password feature is case-sensitive.
c) The Main Menu or the "Ready" prompt will be displayed. If the
"Ready" prompt is displayed, press [Enter] to display the VIP
Main Menu.
2. Local Access (Console Port): Start your communications program.
a) If Set-Up Switch 7 is UP (Enable Console Port Password), the
"PollCat- NetLink" (password) prompt will be displayed.
b) Key in a valid password and press [Enter]. Note that the
Password feature is case-sensitive.
c) The Main Menu or the "Ready" prompt will be displayed. If the
"Ready" prompt is displayed, press [Enter] to display the VIP
Main Menu.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com