AUDIO OVER ETHERNET
1. AC INLET
Terminal which inputs the AC power.
2. POWER SWITCH
Switch turning On/Off the AC Power.
3. DC INPUT TERMINAL
Backup battery(24DC) connecting terminal. In case of black out of AC power, connected backup
battery supplies the power to the device. DC 24V input supplies the power to the set regardless of switch On/Off.
4. AUDIO OUTPUT TERMINAL
It consists of 2-channel with balance outputs (Hot, Cold, GND) with transmitted audio output terminal.
5. AUDIO INPUT TERMINAL
It consists of 2-channel with balance outputs (Hot, Cold, GND) with audio output terminal to be transmitted.
6. AUDIO INPUT VOLUME
Control the volume of input audio signal.
Control level is (-10dB ~ +10dB)
7. CONTACT POINT INPUT AND OUTPUT TERMINALS
If contact point signal is inserted in each contact point terminal of transmit AOE-212N device,
contact point signal will be transmitted from the contact point output terminal of transmit AOE-212N device.
Input contact point: Contact point signal can be inserted if pin of each channel is short.
Output contact point: Same signals with input signal will be transmitted on the input contact point of transmitter.
※ Caution: Contact point signal is only transmitted when AOE-212N is operated under normal conditions, and please
input the signal after checking out the equipment operation status. Because data is transmitted in real times, signal
will not be transmitted when device is off.
AC INPUT 220V~ 60Hz
CH2 CH1 CH2
24V OUTPUT INPUT
AOE-212N_MANUAL_137029_FOR_MA-206_212_E 15. 4. 29. 오전 10:16 페이지 6