Loading...
6-5
Operation
To switch plugs On or Off, initiate a Boot Cycle, or set plugs to default
On/Off status, proceed as follows:
1. Switch Plug(s) On: To power-on a plug, type /ON n and press
[Enter]. Where "n" is the number or name of the desired plug.
For example:
/ON 1 or /ON ROUTER
2. Switch Plug(s) Off: To power-off a plug, type /OFF n and press
[Enter]. Where "n" is the number or name of the desired plug. Note
that the "/OFF" command can also be entered as "/OF". For example:
/OFF 2 or /OF ROUTER
3. Boot Plug(s): To initiate a Boot cycle, type /BOOT n and press
[Enter]. Where "n" is a the number or name of the desired plug. Note
that the "/BOOT" command can also be entered as "/BO".
For example:
/BOOT 1 or /BO ATMSWTCH
4. Set Plugs to Power Up Defaults: To set each plug to it's user defined
default On/Off status, type /D and press [Enter]. Plugs will be set
to their Power Up Default Status, which is defined using the Plug
Parameters Menu as described in Section 5.3.3.
Note:
When you have accessed command mode using the System
Password, the Default command will be applied to all IPS outlets.
When you have accessed command mode using a Plug/User
Password, the Default command will only be applied to the plugs
that are permitted by the password.
5. Suppress Command Confirmation Prompt: To execute a Boot/On/
Off command without displaying the "Sure?" prompt, include the ",Y"
option at the end of the command line. For example:
/ON ROUTER,Y or /BOOT 2,Y
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com