Loading...
17-25
Command Reference Guide
^B89 Test Alpha Pager
To test an alphanumeric pager, type ^B89,1 [Enter], and then exit
command mode. After approximately two minutes, the pager should
receive the "Pager Test" message. In order for this command to function,
the Pager Phone Number and Pager ID Number must first be defined via the
Pager Test Submenu.
Corresponding Menu Function: System Diagnostics Menu, Item 3.
^B90 Reset Modem Port / Define Modem Port
Communication Parameters
(Administrator Mode Only) This command can be used to reset
NetLink II's internal modem or redefine modem communication parameters.
Reset Modem: To reset the modem, use the following format:
^B90 Reset Modem
^B90,Y Reset Modem, Suppress "Sure?" Prompt.
Configure Modem Port: To define modem communication parameters,
use the following format:
^B90,baud,parity,data,stop [Enter]
Where:
baud Baud Rate: Any standard rate from 300 bps to 115.2 Kbps.
It is only necessary to enter the first two characters of the
baud rate. If an asterisk is entered in this field, the port will
be set to the default modem port baud rate (57.6 Kbps).
parity Parity Bits: None (n), Odd (o), or Even (e)
data Data Bits: 7 or 8
stop Stop Bits: 1 or 2
Corresponding Menu Function: Reset: Modem Port Configuration
Menu, Item 7; Define: Modem Port Configuration Menu.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com