Loading...
17-12
PollCat NetLink II - User’s Guide
^B29 Enter Pass-through Mode
(Administrator Mode Only) Allows direct communication with a
connected device. Data can be received directly from the PBX in order
to check for correct reception. Commands can also be sent directly to the
PBX. While Pass-Through Mode is active, additional call records will not
be stored. To exit Pass-Through Mode, type ^B30 and press [Enter].
CAUTION: Do not attempt to alter PBX configuration unless
you are authorized to do so. Please refer to the PBX user's
guide for further instructions.
Command Options:
^B29 Pass-Through to Serial PBX Port.
^B29,A Pass-Through to Serial PBX Port.
^B29,I Pass-Through to PBX IP Port.
^B29,C Pass-Through to Console Port.
^B29,M Pass-Through to Modem Port.
Corresponding Menu Function: System Functions, item 1.
^B30 Exit, Return to Command Mode
Exits from Data Release Mode, Send Continuous Test Message Mode, Echo
Test Mode, Pass-Through Mode, or Monitor Mode and returns to command
mode. Type ^B30 [Enter].
^B39 Erase All Data
Erases all stored data, including records stored outside your port's memory
partition. Command ^B39 includes an option that allows the user clear all
data and reset all Alarm Clue Counters to zero.
CAUTION: Erased call records cannot be restored.
If the "Sure" option is enabled, a prompt will be displayed. Type Y to
proceed, or N to abort, and then press [Enter].
Command Options:
^B39 Clear all records, leave Alarm Clue Counters intact.
^B39,2 Clear all records and reset Clue Counters to zero.
^B39,Y Suppress "Sure" prompt, Clear all records, leave Alarm Clue
Counters intact. Note that the Y argument can also be
combined with the "2" argument (e.g., ^B39,2,Y).
Corresponding Menu Function: Buffer Functions, item 6.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com