Loading...
17-4
PollCat NetLink II - User’s Guide
17.3. Command Syntax
Most commands conform to the following conventions:
In the command line examples shown in this section, square braces
([ ]) are used to indicate an optional argument, and greater than /
less than symbols (< >) are used to indicate a required argument. For
example, in the sample command line ^B[,port]<,action>,
"port" would be an optional argument and "action" would be a
required argument.
Commands normally begin with the ASCII "Control B" character
(written as ^B throughout this manual).
To temporarily suppress the Command Echo for any command, use the
^A character in place of the ^B character. For example, if Command
Echo is enabled and Command ^B03 (Send Site ID) is invoked,
NetLink II will echo the command back to the polling device and send
the Site ID message. If ^A is substituted for ^B (e.g. ^A03), the Site
ID message will be sent, but the command will not be echoed back to
the polling device.
Each command is invoked by pressing the [Enter] key.
A comma (,) is used to separate a command from its options or
parameters (e.g. ^B01,10).
17.4. Command Summary
^B00 Set/Reset Memory Partition
Sets or releases the memory partition for your command port.
Notes:
If this command does not include an argument, the partition will
be set to include all data by default.
The Release partition argument (R) cannot be combined with
other arguments.
The ^B00 command line can specify two source ports (e.g.,
^B00,PA,PI), but cannot specify two data types.
Square brackets are not included in the command line. They are
shown here to indicate an option.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com