Loading...
17-1
17. Command Reference Guide
17.1. Command Mode Access
When the NetLink II has been properly installed and configured, command
mode can be accessed by a local PC connected directly to the Console Port,
by a remote PC that communicates via modem, or via TCP/IP network.
Notes:
If the Site I.D. Message (System Parameters Menu, Item 4) has
been defined, the Site I.D. will be displayed before the "PollCat-
NetLink" prompt.
When the Administrator Password is entered, NetLink II will
start up in Administrator Mode, allowing access to all menu
functions. When a User password is entered, NetLink II will
start up in User Mode, which allows limited access to menu
functions.
The Default Administrator Mode Password is SUPER, and the
default User Mode Password is SMDR.
1. Remote Access (via Modem): Start your communications program
and dial the NetLink.
a) The unit will respond with the "PollCat-NetLink" (password)
prompt after the carrier is detected.
b) Key in a valid password and press [Enter]. Note that the
Password feature is case-sensitive.
c) The Main Menu or the "Ready" prompt will be displayed. If
the "Ready" prompt is displayed, press [Enter] to display the
NetLink II Main Menu. Note that if the Dialback Number has
been defined for your User Account, NetLink II will perform a
dialback operation before allowing access to command mode.
For more information, please refer to Section 5.4.4.1.
2. Local Access (Console Port): Start your communications program.
a) If Set-Up Switch 1 is UP (Enable Console Port Password), the
"PollCat- NetLink" (password) prompt will be displayed.
b) Key in a valid password and press [Enter]. Note that the
Password feature is case-sensitive.
c) The Main Menu or the "Ready" prompt will be displayed. If
the "Ready" prompt is displayed, press [Enter] to display the
NetLink II Main Menu.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com