Loading...
En-11
Connecting the Receiver—Continued
On the receiver, the factory default for speaker impedance is “6 Ω”. If you need to change the speaker impedance setting,
read “Speaker Connection Precautions” on page 9 carefully before performing the procedure below.
Note:
Be sure to minimize the volume level on the receiver
before configuring the speaker impedance.
1Press the [] button to turn on the power.
2Press the [SETUP] button on the remote
controller.
3Use the arrow []/[] buttons to select
“2. Hardware Setup,” and then press
[ENTER].
4Change the impedance value to “4 Ω” using
the arrow []/[] buttons.
5Press the [SETUP] button on the remote
controller to complete the setting.
If you want to change the impedance setting back
to the factory default setting of 6 Ω, follow the
same procedure described above.
Notes:
This procedure can also be performed on the receiver
by using [SETUP,] TUNING []/[], PRESET
[]/[], and [ENTER].
Press [RETURN] button to return to the previous
menu.
Setting example :
If you’re using only one of the speaker sets connected to
SPEAKERS A or B, choose the 4 Ω setting if each
speaker’s impedance is 4 Ω to less than 6 Ω, or choose
the 6 Ω setting if each speaker’s impedance is 6 Ω or
more.
If you’re using both of the speaker sets connected to
SPEAKERS A and B, choose the 4 Ω setting if each
speaker’s impedance is 8 to 16 Ω.
Configuring the Speaker Impedance
ENTER

SETUP
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com