Loading...
ZONE 6
L
R
Pre Out
ZONE 5
L
R
Pre Out
ZONE 4
L
R
Pre Out
SOURCE 5
IR In
IR Out
Video Sync
L
R
In Out
SOURCE 4
IR In
IR Out
Video Sync
L
R
In Out
SOURCE 3
IR In
IR Out
Video Sync
L
R
In Out
SOURCE 6
3-30V AC/DC Sync3-30V AC/DC Sync3-30V AC/DC Sync3-30V AC/DC Sync IR In
IR Out
Video Sync
L
R
In Out
1 2 3 4 5 6 Out to Master
7 8 9 10 11 12
ZONE 3
L
R
Pre Out
ZONE 2
L
R
Pre Out
ZONE 1
8 Ω (4 Ω Min.)
Speaker Outputs
8 Ω (4 Ω Min.)
Speaker Outputs
8 Ω (4 Ω Min.)
Speaker Outputs
8 Ω (4 Ω Min.)
Speaker Outputs
8 Ω (4 Ω Min.)
Speaker Outputs
8 Ω (4 Ω Min.)
Speaker Outputs
L
R
Pre Out
12V TRIGGERS
1
4
2
5
3
6
iPOD
L
R
OutInOut
Cascade Audio In
AM/FM
TUNER
L
R
HD Radio
COMMUNICATION PORTS
Page Sync
Page In
HT
Sync
Global
12V
Trigger
Global
IR Out
Global
IR In
120 Volts ~ 60Hz. 1500 Watts Max.
Figure 4. VS-6 connected to a Niles Network MultiZone Receiver
CAT-5
L/R Audio
Component Video
12 Volt
Flasher
Speaker Wire
Component Video Sources
8
SYSTEM CONFIGURATION 3
VS-6 CONNECTED TO A NILES NETWORK MULTIZONE RECEIVER
SYSTEM CONFIGURATION 3
(The VS-6 is designed to integrate with the MultiZone receiver’s commands and route
the video of up to six audio/video sources to as many as six zones)
1. Two component video sources are connected to Component Video Inputs 3 and 4. The video
sources’ audio signals get connected to the corresponding audio inputs on the Niles Network
MultiZone Receiver.
2. Balanced Video Output for Zone 5 of the VS-6 is sent to its respective room using cabling
through the wall. The local room control CAT-5 cable is for connection to, and communication
with, the optionally supplied IRG (Infrared Gateway FG01426).
3. The VS-6 gets its control command from the Niles Network MultiZone Receiver via an Ethernet
connection cable from the Niles Network MultiZone Receiver’s Communication and Control con-
nection ports to the VS-6’s rear panel Out to Master RJ-45 connection port.
ABOUT THE IRG (INFRARED GATEWAY)
An IRG is essential for the operation and control of each TV connected to the VS-6. The IRG
“monitors” the power status of the TV and issues IR commands to make sure that the TV is pow-
ered on and switches to the correct input when a Master Key is pressed on the Niles Network
MultiZone Receiver keypads or touch screen interfaces. The TV’s power status is detected using
Source 1
Source 2
Power Cord
Keypad
Flat Panel Display
CS12V IRG
C5-HDDAWM
VS-6
Niles Network MultiZone Receiver
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com