Loading...
10-3
SNMP Traps
10.4. Testing the SNMP Trap Function
After you have finished setting up the SNMP Trap function, it is recommended
to test the configuration to ensure that it is working correctly. To test
configuration of the SNMP Trap function, proceed as follows:
1. Configure the SNMP Trap function as described in Section 10.1.
2. Access the Text Interface command mode using an account and port that
permit Supervisor commands, then invoke the "/TEST" command at the
RSM command prompt. Note that the /TEST Command is only available
in Supervisor Mode.
3. Select Item 1 or 2 to send an SNMP test trap to Manager 1 or 2,
respectively. It is possible that the ARP table will not be properly
setup. If this occurs a message to that effect is displayed and the RSM
immediately refreshes the ARP table. Repeat steps 2 and 3 to try again.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com