RSM Series; Remote Site Managers - User’s Guide
Hunt Group Example 1:
1. Ports 1 and 2 are Modem Mode ports, and modems are installed at both
ports. Port 1 is named "MODEM1" and Port 2 is named "MODEM2".
2. Your resident port is Port 4. To connect to the first available Modem, type
/C MODEM* [Enter].
Hunt Group Example 2:
1. Ports 3, 4, and 5 are Any-to-Any Mode ports. All three ports are named
2. Your resident port is Port 1. If you want to connect Port 2 to the first
available server, type /C 2 SERVER [Enter].
7.2. Passive Mode
Passive Mode Ports function the same as Any-to-Any Mode Ports, but do not
allow access to command mode. A Passive Mode Port can communicate with
other ports, but cannot enter command mode, and therefore cannot redefine
parameters, display status, or connect or disconnect ports. The Passive Mode
is the default at Serial Ports 3 and above.
Passive Mode Ports can be connected by accessing command mode from a free
Any-to-Any or Modem Mode Port, and invoking the Third Party Connect or
Resident Connect Command as described in Section 7.1.1. Passive Mode ports
will not buffer data, except during baud rate conversion.
Note: In order to ensure Supervisor access to important command
functions, the Passive Mode is not available to Port 1 (the SetUp Port.)
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com