Loading...
6-6
RSM Series; Remote Site Managers - User’s Guide
The /W command uses the following format:
/W xx [Enter]
Where xx is the desired port number. If the /W command is invoked at a
serial port, by a user with access to Supervisor Level commands, then the letter
"N" can be entered as the command argument to display parameters for the
Network Port.
Note: When command mode is accessed via the Network Port
using an account that does not permit Supervisor commands, the
/W command will only display the Sequence Disconnect, Logoff
Character, and the status of the Accept Break item.
PORT PARAMETERS #03:
COMMUNICATION SETTING PORT MODE PARAMETERS
1. Baud Rate: 9600 21. Port Name:
2. Bits/Parity: 8-None 22. Port Mode: Passive
3. Stop Bits: 1 23. DTR Output: Pulse
4. Handshake: RTS/CTS 24. Buffer Params: ---
25. Modem Params: ---
GENERAL PARAMETERS NETWORK SERVICES
11. Supervisor Mode: Permit 31. Direct Connect: Off
12. Logoff Char: ^X Telnet Port: ---
13. Sequence Disc: One Char SSH Port: ---
14. Inact Timeout: 5 Min Raw Port: ---
15. Command Echo: On 32. Syslog: ---
16. Accept Break: On 33. SNMP Trap Lv: ---
RSM>
NETWORK PARAMETERS:
COMMUNICATION SETTING SERVERS AND CLIENTS
1. IP Address: 207.212.30.80 21. Telnet Access: On
2. Subnet Mask: 255.255.255.0 22. SSH Access: On
3. Gateway Addr: 207.212.30.1 23. Web Access: On
4. DHCP: Off 24. SYSLOG IP addr: (undefined)
5. IP Security: Off 25. SNMP Access: Off
6. Static Route: Off 26. SNMP Trap: Off
27. TACACS: Off
GENERAL PARAMETERS 28. RADIUS: Off
11. Supervisor Mode: Permit 29. PING Access: On
12. Logoff Char: ^X 30. Raw Socket Access: Off
13. Sequence Disc: One Char
14. Inact Timeout: 5 Min
15. Command Echo: On
16. Accept Break: On
RSM>
Figure 6.4: Port Parameters Screen (RS232 Port Shown)
Figure 6.5: Port Parameters Screen (Network Port Shown)
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com