Loading...
5-27
Confi guration
Syslog: The Syslog feature is used to create records of each buffer event.
As event records are created, they are sent to a Syslog Daemon, at an IP
address defined via the Network Parameters menu. For more information,
please refer to Section 9. The Syslog feature offers three possible
settings. (Default = Off)
Off: Syslog disabled. (Default)
On - Not Connected: Messages will only be generated when a user
is not connected to a buffer port (either by /C or direct connect.) This
prevents information captured from the attached device from being put
into Syslog messages while a user is connected to a buffer port.
On - Always: All captured information will be sent out via Syslog
message; whether a user is connected or not.
Notes:
Syslog is only available at Buffer Mode Ports.
This option is not available to RS232 Ports 1 and 2, because Ports 1
and 2 cannot be configured as Buffer Mode Ports.
The Port Parameters menu also offers two additional items used to set the
priority of Syslog messages generated by this port:
Facility: The facility under which this port will log messages.
(Default = Local_0.)
Level: The severity (or priority) of messages generated by this port.
(Default = Emergency.)
SNMP Trap Level: Enables/disables the SNMP Trap function and sets
the byte level that will generate traps at this port. If set to "0" (zero), then
SNMP Traps are disabled at this port.
If this value is set between 1 and 32,767, then the SNMP Trap function
is enabled, and traps will be sent to the SNMP Managers whenever the
buffer for this port reaches the specified level. For more information,
please refer to Section 10. (Default = Off.)
Note:
The SNMP Trap feature only applies to Buffer Mode Ports.
This option is not available to RS232 Ports 1 or 2. This is because
Ports 1 and 2 are reserved as SetUp Ports, and cannot be configured
as Buffer Mode Ports.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com