Loading...
3-6
Getting Started
3.3. Communicating with the RPC Unit
In order to ensure security, both Telnet and Web Browser Access are disabled when
the RPC is shipped from the factory. To enable Telnet and/or Web Browser access,
please refer to Section 6.8. When properly installed and configured, the RPC can allow
command mode access via Telnet, Web Browser, SSH client, modem, or local PC.
Notes:
• DefaultRPCserialportparametersaresetasfollows:9600bps,RTS/
CTSHandshaking,8DataBits,OneStopBit,NoParity.Althoughthese
parameterscanbeeasilyredefined,forthisQuickStartprocedure,itis
recommendedtoconfigureyourcommunicationsprogramtoacceptthe
default parameters.
• TheRPCfeaturesadefaultIPAddress(192.168.168.168)andadefault
SubnetMask(255.255.255.0.)Thisallowsnetworkaccesstocommand
mode,providingthatyouarecontactingtheRPCfromanodeonthesame
subnet.WhenattemptingtoaccesstheRPCfromanodethatisnoton
thesamesubnet,pleaserefertotheUser’sGuideforfurtherconfiguration
instructions.
1. AccessCommandMode: The RPC includes two separate user interfaces; the Text
Interface and the Web Browser Interface. The Text Interface is available via Local
PC, SSH Client, Telnet, or Modem. The Web Browser interface is only available via
TCP/IP network.
a) ViaLocalPC: Start your communications program and then press [Enter].
b) ViaSSHClient: Start your SSH client, enter the default IPv4 format IP address
(192.168.168.168) for the RPC and invoke the connect command.
c) ViaWebBrowser: Make certain that Web Browser access is enabled as
described in the RPC User’s Guide. Start your JavaScript enabled Web
Browser, enter the default IPv4 format IP address (192.168.168.168) in the Web
Browser address bar, and then press [Enter].
d) ViaTelnet: Make certain that Telnet access is enabled as described in the
RPC User’s Guide. Start your Telnet client, and enter the default IPv4 format IP
address (192.168.168.168).
e) ViaModem: Make certain that the RPC Console Port has been configured
for Modem Mode as described in the RPC User's Guide, then use your
communications program to dial the number for the external Modem
connected to the Console Port.
2. Username/PasswordPrompt: A message will be displayed, which prompts you
to enter your username and password. The default username is "super" (all lower
case, no quotes), and the default password is also "super". If a valid username and
password are entered, the RPC will display either the Circuit Control Screen (Web
Browser Interface) or the Circuit Status Screen (SSH, Telnet, or Modem).
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com