Loading...
8-14
Alarm Configuration
8.6. The Power Cycle Alarm
The Power Cycle Alarm can provide notification when all input power to the RPC unit is
lost and then restored. When the power supply is lost and then restored, the RPC can
provide notification via Email, Syslog Message or SNMP Trap.
Notes:
• Thisalarmwillnotfunctionwhenonlyonepowerinputisdisconnected.To
provide notification when one power input is lost or disconnected, please
usetheLostVoltage(LineIn)AlarmasdescribedinSection8.3.
• InorderfortheRPCtoprovidealarmnotificationviaEmail,communication
parametersmustfirstbedefinedasdescribedinSection6.8.10.
• InorderfortheRPCtoprovidealarmnotificationviaSyslogMessage,Syslog
parametersmustfirstbedefinedandSyslogMessagesmustbeenabledas
describedinSection6.8andSection11.
• InorderfortheRPCtoprovidealarmnotificationviaSNMPTrap,SNMP
parametersmustfirstbedefined,andSNMPTrapsmustbeenabledas
describedinSection6.8.6andSection12.
To configure the Power Cycle Alarm, you must access the RPC command mode using
a password that permits Administrator Level commands. The Power Cycle Alarm
configuration menu offers the following parameters:
• TriggerEnable: Enables/Disables the trigger for this alarm. When Disabled, this
alarmwillbesuppressed.(Default=On.)
Note:
• Tocancelanalarmwithoutcorrectingtheconditionthatcausedthealarm,
simplytoggletheTriggerEnableparameterOffandthenbackOnagain.
• TheTriggerEnable,EmailMessageandAddress1,2and3Parametersall
include"CopytoAllTriggers"optionsthatallowyoutoenable/disablethe
correspondingparameterforallRPCalarms.Forexample,ifthePower
CycleAlarm'sTriggerEnableparameterissetto"On(CopytoAllTriggers),
thenotherRPCalarmswillalsobeenabled.
• EmailMessage:Enables/Disablesemailnotificationforthisalarm.(Default=On.)
• Address1,2,and3: These parameters are used to select which of the three email
addresses defined via the "Email Messages" menu (see Section 6.8.10) will receive
the email alarm notification messages generated by this alarm. The Address
parameters can be used to select one, or any combination of the addresses defined
viatheEmailMessagesmenu.(Default=AllOn.)
Note:IfEmailaddresseshavebeenpreviouslyspecified,thenthetextunder
the parameters will list the current, user defined email addresses.
• Subject: This parameter is used to define the text that will appear in the "Subject"
fieldforallemailnotificationmessagesgeneratedbythisalarm.(Default="Alarm:
Power Cycle")
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com