Loading...
8.2.4. Terminating a Direct Connect Session
To terminate a Direct Connect session, use the client Telnet
program's "disconnect" feature. The following will occur
immediately upon a client initiated disconnect:
1. The Network port is disconnected from the RS232 Port.
2. The Network session is terminated.
3. The RS232 Port is put to sleep.
Notes:
·The Sequence Disconnect Command, which is
defined via the Port Configuration menus (CMS
User's Guide, Section 5.5) cannot be used to
terminate a Direct Connection.
·Any CMS port that has accessed the Command
Mode using the Supervisor Level Password can
terminate a direct connection at another port by
issuing the /D command as described in
Section 7.1.1.2.
·Acknowledgment of data received by the CMS
network port does not indicate that the data has
been completely sent out the serial port. Data may
still be queued in the CMS buffers. Any data
queued in the CMS at the time of a client initiated
disconnect is discarded, and is not passed through
to the attached device.
8.3. Inbound Telnet Connections
The CMS-16 will support up to seventeen simultaneous inbound
Telnet connections; the CMS-8 will support up to nine
simultaneous inbound Telnet connections.
8-6
CMS-16 / CMS-8 User's Guide
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com