Loading...
To Connect ports, proceed as follows:
1. Access the Command Mode.
2. Invoke the /C command to connect the desired ports.
a) Resident Connect: To connect your resident port to
another port, type /C xx [Enter]. Where xx is the
number or name of the port you want to connect. The
CMS will display the numbers of the connected ports,
along with the command sequence that will be required
in order to disconnect the two ports.
Example: To connect your resident port to Port 8, type
/C 8 [Enter].
b) Third Party Connect: (Supervisor Mode Only) To
connect any two ports (other than your resident port),
type /C xx XX [Enter]. Where xx and XX are two
port names or numbers. The CMS will display the
numbers of the two connected ports.
Example: To connect Port 5 to Port 6, invoke the
following command at a port with Supervisor Level
command capability: /C56[Enter].
Notes:
·Resident Connections: RS232 Ports are not
allowed to initiate a Resident Connection to the
Network Port.
·Third Party Connections: RS232 Ports are not
allowed to connect another port to the network
port. For example, Port 1 is not allowed to connect
Port 3 to the Network Port.
When the /C command specifies the port name, it is only
necessary to enter enough letters to differentiate the desired port
from other ports. Type an asterisk (*) to represent the remaining
characters in the port name. For example, to connect your
resident port to a port named "SALES", the connect command
can be invoked as /C S*, providing no other port names begin
with the letter "S".
7-2
CMS-16 / CMS-8 User's Guide
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com