Loading...
The /W command uses the following format:
/W[P] xx [Enter]
Where:
PIs the command option to display port passwords. Note
that when this option is included (e.g. /WP 5), the Port
Parameters Screen will display the Port Password, if
defined. (Supervisor Mode Only).
xx is the desired port number. If the letter ā€œNā€ is entered in
place of a port number, the /W command will display
parameters for the Network Port.
Note: When the command mode is accessed via the
Network Port using a Port (User) password, the /W
command will only display the Sequence Disconnect,
Logoff Character, and the status of the Accept Break
item.
6-8
CMS-16 / CMS-8 User's Guide
Figure 6.5: Port Parameters Screen (Network Port Shown)
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com