Loading...
17. Accept Break: Determines whether the port will accept
breaks received from the attached device, and pass them
along to a connected port. When enabled, breaks received
at this port will be passed to any port that this port is
connected to, and sent along to the device connected to the
other port. When disabled, breaks will be refused at this
port. (Default = Yes)
18. Discard <LF> after <CR>: If desired, this option can be
used to discard the Line Feed character that is often
produced by telnet software. When this parameter is
enabled, the <LF> character sent after the <CR> will not
be forwarded to the serial port that the telnet connection is
in session with. When the status of this parameter is
changed the new setting will take effect immediately, thus
changing all current, active connections. This parameter
applies to all CMS telnet connections. (Default = Off)
19. Password: Defines the optional password for outbound
Telnet connections. Note that if this password is not
defined, then only the Supervisor Mode be able to initiate
an outbound Telnet connection. For more information on
outbound telnet connections, please refer to Section 8.4.
(Default = undefined).
Notes:
·The outbound Telnet password can either be set to
match any User Mode password, or it can be
different from existing User Mode Passwords.
·If the outbound Telnet password is the same as a
User Mode password, then only that user may
initiate an outbound Telnet connection.
·If the outbound Telnet password is different from
all User Mode passwords, then any user can initiate
an outbound Telnet connection, but they must first
logoff from the CMS command mode, and then re-
login using the currently defined outbound Telnet
password.
5-18
CMS-16 / CMS-8 User's Guide
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com