Loading...
5. Configuration
5.1. Access to the CMS Command Mode
When the CMS Command Mode is active, commands can be
invoked to select parameters, and connect or disconnect ports.
Note: Command Mode cannot be accessed from a
Buffer Mode Port, Passive Mode Port, or any port
that is currently connected to another CMS port.
1. Start your communications program (e.g. HyperTerminal).
Make certain the CMS and your communications program
are set for the same parameters (e.g. baud, parity, etc.).
2. Access the Command Mode.
a) Local Access: To access command mode from a local
PC connected to the CMS via cable, press [Enter].
i. If you have already hit other keys, press [Enter]
twice. There must be no other characters preceding
[Enter].
ii. If the Supervisor Password has been defined, the
password prompt will be displayed. Key in your
Supervisor or Port password and press [Enter]. The
"CMS>" prompt will appear.
b) Modem Access: To access the command mode via
modem, proceed as follows:
i. Dial the number for the external modem connected
to the CMS.
ii. If you have defined the Supervisor Password, a
prompt will be displayed. Key in your Supervisor
or Port password and press [Enter]. If the
Supervisor Password has not been defined, just
press [Enter]. The "CMS>" prompt will appear.
5-1
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com