Loading...
5-3
Confi guration
3. Password Prompt: The NBB will display a prompt, which asks for
your name and password.
a) User Name: If you have not previously defined a user name, then
this field should be left blank. A user name is only required when
one has been defined via the General Parameters menu.
b) Password: Key in your System Password or Plug Password and
then click "OK" (Note that Plug Passwords do not permit access to
configuration functions.)
c) If the System Password has not been defined, simply click the "OK"
button without keying in a name or password.
If a valid password is entered, the Plug Status Screen will appear.
5.2.2. Accessing the Text Interface
The Text Interface can be accessed via Network, modem or local PC. In order
to access the Text Interface, your installation must include the following:
Access Via Network: The NBB must be connected to your TCP/IP
Network, and your PC must include a communications program (such as
Hyperterminal™.)
Access Via Modem: An external modem must be connected to the
NBB’s Console Port, and a phone line must be connected to the external
modem. Your PC Must include a communications program.
Access Via Local PC: Your local PC Must be connected to the NBB’s
Console Port. The local PC must include a communications program.
To access command mode via the Text Interface, proceed as follows:
1. The NBB is transparent to parity and will accept 7 or 8 bit characters,
but will always answer back at 8 bits, no parity. Make certain your
communication program is set for the appropriate baud rate, bits, parity
and Comm Port.
a) Via Modem: Start your communications program. Dial the
external modem connected to the NBB. Wait for the Connect
message, then proceed to Step 2.
b) Via Local PC: Start your communications program and press
[Enter]. Wait for the connect message, then proceed to Step 2.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com