Loading...
6-7
Operation
To enable/disable the Automated Mode, access the General Parameters
menu (see Section 5.3.1,) then set the "Automated Mode" option to "On".
When Automated Mode is enabled, IPS functions will change as follows:
1. All Password Security Suppressed: When a user attempts to access
command mode, the password prompt will not be displayed at either
the Console / RS232 Port or the Network Port. Unless specifically
restricted by the IP Security Function, all users will be allowed to
access both switching and configuration functions, and all commands
will be immediately accepted without the requirement to enter a
password.
2. Status Screen Suppressed: The status screens will not be
automatically displayed after commands are successfully executed.
Note however, that the /S command can still be invoked to display the
status screen as needed.
3. "Sure?" Prompt Suppressed: All commands are executed without
prompting for user confirmation.
4. Error Messages Suppressed: If the [Enter] key is pressed without
entering a command, the IPS will not respond with the "Invalid
Command" message. Note however, that an error message will still be
generated if commands are invoked using invalid formats
or arguments.
All other status display and configuration commands will still function as
normal.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com