Loading...
5.5.5. Implementing IP Security
The CMS can be configured to restrict unauthorized IP addresses
from establishing an inbound Telnet connection to the unit. This
allows the user to grant Telnet access to only a specific group of
IP Addresses, or block a particular IP address. In the default
state, the CMS accepts incoming IP connections from all hosts.
To configure the IP Security feature, proceed as follows:
1. Access the Network Parameters menu as described in
Section 5.5.4. Note that the Network Parameters menu is
only available in Supervisor Mode.
2. When the Network Parameters menu appears, type 4and
press [Enter] to access the IP Security menu (Figure 5.5).
3. The IP Security Menu lists five IP Security “masks” along
with the selected permit/deny action for each mask.
a) Each Security Mask prompt is used to define a specific
IP address or range of IP addresses. Each Mask Action
prompt is used to select the permit/deny action for the
corresponding mask.
b) Masks are listed in order of ascending priority; Mask 1
has the lowest priority, and Mask 5 has the highest
priority.
c) Masks have a cumulative effect; high priority masks
supersede the effect of lower priority masks.
d) Each IP Address consists of a series of four eight bit
numbers. The number 255 is used as a wild card.
5-23
Configuration
IP SECURITY:
1. Mask #1: (undefined)
2. Action #1: Permit
3. Mask #2: (undefined)
4. Action #2: Permit
5. Mask #3: (undefined)
6. Action #3: Permit
7. Mask #4: (undefined)
8. Action #4: Permit
9. Mask #5: (undefined)
10. Action #5: Permit
Enter: #<CR> to select menu,
<ESC> for previous menu ...
Figure 5.5: IP Security Menu
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com