Loading...
11. Supervisor Mode (Except 2001): Permits or denies access
to the Supervisor Mode. When enabled (Permit), and the
valid Supervisor Password is entered, this port may then
issue Supervisor level commands. If disabled (Deny), the
port may not enter Supervisor Mode, even when the
Supervisor Password is entered. (Default = Permit).
Note: In order to ensure that remote administrators
will always be able to access Supervisor Level
commands via network, the Supervisor Mode cannot
be disabled at CMS Network Port N33. For more
information, please refer to Section 8.1.
12. Logoff Character: Defines the Logoff Character for the
Network Port. Determines the command(s) or character(s)
that must be issued at this port in order to disconnect from
a second port. (Default = ^X ([Ctrl] plus [X])).
Note: The Logoff Character cannot be used to
terminate a telnet "Direct Connection" or an outbound
Telnet connection. For more information, please refer
to Section 8.2.4.
13. Sequence Disconnect: Enables/Disables and configures
the Resident Disconnect command. This prompt offers the
options to disable the Sequence Disconnect, or select a one
character or three character format. (Default = One
Character). Note the following:
·When a Resident Connection is initiated, the CMS will
send a message which lists connected ports, and displays
the one character or three character disconnect command
that will be required in order to terminate the connection.
·The One Character Disconnect is intended for situations
where the destination port should not receive the
disconnect command. When the Three Character format
is selected, the disconnect sequence will pass through to
the destination port prior to breaking the connection.
·When Three Character format is selected, the Resident
Disconnect uses the format “[Enter]LLL[Enter]”, where
Lis the selected Logoff Character.
·When the One Character format is selected, resident
connections are terminated by entering the selected
Logoff Character only. There is no need to press [Enter]
before and after the Logoff Character when the One
Character format is selected.
5-20
CMS-32 Console Management Switch; User's Guide
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com