- 57 -
The available flash range
Shutter speed for each flash setting
¢1The shutter speed changes depending on the [Stabilizer] setting.
¢2 When [ ] in [Sensitivity] is set.
¢1, 2: The shutter speed becomes a maximum of 1 second in the following cases.
When the Optical Image Stabiliser is set to [OFF].
When the camera has determined that there is very little jitter when the Optical Image Stabiliser is
set to [ON].
In Intelligent Auto Mode, shutter speed changes depending on the identified scene.
The shutter speed for [Sports], [Snow], [Beach & Surf], [Advanced Underwater] and Scene Modes
will be different from above table.
If you bring the Flash too close to an object, the object may be distorted or discoloured by the heat or
lighting from the Flash.
Recording a subject from too close, or without sufficient flash will not provide the appropriate level of
exposure, and may result in a picture that is too white or dark.
When the Flash is being charged, the Flash icon blinks red, and you cannot take a picture even
when you press the shutter button fully.
If recording a subject without sufficient flash, the White Balance may not be properly adjusted.
The effects of the flash may not be adequately achieved under the following conditions.
When [Burst] in the [Rec] menu is set to [ ]
When the shutter speed is too fast
It may take time to charge the Flash if you repeat taking a picture. Take a picture after the access
indication disappears.
The Red-Eye Reduction effect differs between people. Also, if the subject is far away from the
camera or was not looking at the first Flash, the effect may not be evident.
Wide Te le
In [ ] in
[Sensitivity] 30 cm (0.98 feet) to 4.4 m (14 feet) 1 m (3.3 feet) to 3 m (9.8 feet)
Flash setting Shutter speed (Sec.) Flash setting Shutter speed (Sec.)
1/60 to 1/1300 1 or 1/8 to 1/1300¢1
1 or 1/4 to 1/1300¢2
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com