- 31 -
Dynamic Range Compression
You can listen at low volumes but still hear dialog
(Dolby Digital, Dolby Digital Plus and Dolby
TrueHD only)
“Auto” is effective only when playing Dolby
Digital Audio Output
Press [OK] to show the following settings:
hDolby Audio
Select the audio signal to output.
Select “PCM”, when the connected equipment
cannot decode the respective audio format.
This unit decodes the audio format and
transmits to the connected equipment.
If you do not make proper settings the audio
may be static or noisy.
If you set “Voice Guidance Setting” to “On”,
these settings will be fixed to “PCM”.
hBD-Video Secondary Audio
Select whether or not to mix the primary and
secondary audio (including the button click
If “Off” is selected, the unit outputs the primary
audio only.
To enjoy BD-Video that supports Dolby Atmos® or
Connect this unit to an AV amplifier or similar device that
supports it with an HDMI cable, and select the following
–Dolby Audio: “Bitstream”
–DTS/DTS-HD: “Bitstream”
–BD-Video Secondary Audio: “Off”
Dolby Atmos is a trademark of Dolby Laboratories.
OPTICAL Down Sampling
Set the maximum sampling frequency to be used
when outputting down-sampled audio from the
OPTICAL terminal.
Set a frequency supported by the connected
When playing back BD-Video, signals are
converted to 48 kHz despite the settings in the
following cases:
–when the signals have a sampling frequency
of 192 kHz
–when the disc has copy protection
–when “BD-Video Secondary Audio” is set to
Select the downmix system of multi-channel to
2-channel sound.
Select “Surround encoded”, when the
connected equipment supports the virtual
surround function.
The downmix effect is not available when
“Digital Audio Output” is set to “Bitstream”.
The audio will be output in “Stereo” in the
following cases:
–AVCHD playback
–Playback of secondary audio (including the
button click sound).
HDMI Output Settings of Music Playback
Minimize the audio noise during music playback
by automatically switching the video output to
Settings for High Clarity Sound
Set a terminal that will stop processing audio
signals or whether or not to turn on/off the unit’s
display when “High Clarity Sound” (>28) is set to
“On (Video Off)” or “On (Video On)”.
Set an option for video playback and audio
Audio Delay
Synchronization between picture and sound is
corrected by adjusting the delay time of the audio
Analog Audio Output
Set this when outputting audio from the Analogue
AUDIO OUT terminal.
If “7.1ch” or “2ch (Downmix)” is selected, audio
will not be output from the HDMI OUT terminal.
When “7.1ch” is selected :
–Speaker presence and size
–Delay time ( )
–Channel balance ( )
To finish the speaker setting
Select “Complete”.
Value Electronics
Factory Direct Authorized Dealer
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com