■ Installing / Removing batteries
Note the correct
polarity (+ or -)
Indicator / Control panel
● When pressing 4, 5, 6 buttons, the control panel
guide appears on the right side of the screen for
3 seconds to highlight which button has been
Rear side of the TV
1 Remote control signal receiver
● Do not place any objects between the TV remote
control signal receiver and remote control.
2 Ambient sensor
● Senses brightness to adjust picture quality when
[Ambient Sensor] in the Picture Menu is set to
3 Power LED
• Depending on the ambient brightness,
adjusts the brightness of LED to easy-to-view
Standby with some functions (recording, etc.)
active or panel maintenance in progress
● The LED blinks when the TV receives a command
from the remote control.
4 Input mode selection
● Press repeatedly until you reach the desired mode.
● Press and hold for about 3 seconds to display main
OK (when in the menu system)
5 Channel Up / Down
● Cursor Up / Down (when in the menu system)
6 Volume Up / Down
● Cursor Left / Right (when in the menu system)
7 Mains power On / Off switch
● Use to switch the mains power.
● To turn Off the apparatus completely, you must pull
the mains plug out of the mains socket.
● [ ]: Standby / On
Be sure to turn the TV off with the remote control to
perform the panel maintenance. During the panel
maintenance, LED turns to orange.
During panel maintenance, avoid touching and exerting
any pressure on the screen. (e.g. wiping the screen,
There are two types of the maintenance as following.
Normal maintenance automatically starts, and it takes
approx. 10 minutes.
Regular maintenance takes approx. 80 minutes.
• When regular maintenance is necessary, the
message appears on the screen after turning the
TV off with the remote control. Follow the on-
• During the panel maintenance, a white horizontal
line appears on the screen for a while. This is not
● For information about panel maintenance, refer to
[eHELP] (Search by Purpose > Watching > For best
picture > Screen Settings)