Loading...
32 ASUS CUBX User’s Manual
Connectors
3. H/W SETUP
3. HARDWARE SETUP
6) Chassis Intrusion Lead (4-1 pin CHASSIS)
This requires an external detection mechanism such as a chassis intrusion moni-
tor/sensor or microswitch. The sensor is triggered when a high level signal is
sent to the Chassis Signal lead, which occurs when a panel switch or light detec-
tor is triggered. This function requires the optional ASUS CIDB chassis intru-
sion module to be installed (see 7. APPENDIX). If the chassis intrusion lead is
not used, a jumper cap must be placed over the pins to close the circuit.
CUBX Chassis Intrusion Alarm Lead
+5VSB_MB
Chassis Signal
GND
CHASSIS
CUBX
®
1
7) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).
CUBX Floppy Disk Drive Connector
NOTE: Orient the red stripe to Pin 1.
Floppy Drive Connector
Pin 1
CUBX
®
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com