Accessing thin client BIOS settings
This section describes about the Wyse 5070 thin client UEFI BIOS settings. While starting a thin client, a Dell logo is displayed for a short
1 During start-up, press the F2 key. and enter the default password Fireport.
The BIOS settings dialog box is displayed.
2 Use the System Setup settings to change the BIOS settings.
NOTE: There is an option to restore BIOS defaults, Factory Defaults, and Custom user settings for Users in the BIOS menu.
BIOS default setting restores the values that was part of the BIOS le. Restoring Factory default restores the BIOS setting
to the values that was congured in factory before shipping the client.
To access the boot menu during start-up, press the F12 key. Use the Boot Selection menu to select or view the boot sequence order as
• Boot from UEFI: Hard Drive, Partition 4
• Onboard NIC (IPV4)
• Onboard NIC (IPV6)
System Setup overview
System Setup allows you to:
• Change the system conguration information after you add, change, or remove any hardware in your thin client.
• Set or change a user-selectable option such as the user password.
• Read the current amount of memory or set the type of hard drive installed.
Before you use System Setup, Dell recommends that you write down the System Setup screen information for future reference.
CAUTION: Unless you are an expert thin client user, do not change the settings for this program. Certain changes can cause your
thin client to work incorrectly.
Boot Sequence allows you to bypass the System Setup–dened boot device order and boot directly to a specic device. During the Power-
on Self Test (POST), when the Dell logo appears you can:
• Access System Setup by pressing the F2 key
• Bring up the one-time boot menu by pressing the F12 key
The one-time boot menu displays the devices that you can boot from including the diagnostic option. The boot menu options are:
• UEFI Boot
– UEFI: Hard drive, Partition 4
– Onboard NIC (IPV4)
– Onboard NIC (IPV6)
• Other options
BIOS overview 35